pjc4616015ae5brq body panel compatible with FORD F-MAX

pjc4616015ae5brq body panel is a precision-engineered replacement designed for LH applications on vehicles compatible with FORD F-MAX. It supports clean exterior alignment and stable mounting where daily fleet operation can cause vibration damage, cracked edges, or loosened fastener seats around the panel perimeter.

The pjc4616015ae5brq body panel is built to hold consistent dimensional tolerances along the mounting line so gaps stay even against surrounding trims. Its profile helps manage moisture runoff and reduce dirt packing at contact edges, which is especially useful for regional distribution trucks operating in wet conditions and frequent depot maneuvering.

Installation is direct-fit: remove the old panel, clean the mounting surface, confirm guide point alignment, then tighten fasteners evenly to avoid stress points. For ordering control and warehouse picking accuracy, the reference should be matched to PJC4616015AE5BRQ. The pjc4616015ae5brq body panel is intended to fit without modification when the mounting configuration matches.

For fleet inventory planning, label visibility improves repeat ordering and reduces returns for applications compatible with FORD F-MAX. Fitment should be confirmed by OE reference and mounting configuration before ordering, especially if the vehicle has repaired brackets or replaced surrounding trim.

Packing weight: 0.10 KG  •  Quantity in box: 1  •  Quantity in pallet: 0

• SKU planning: keep PJC4616015AE5BRQ visible for repeat ordering compatible with FORD fleets.
• Warehouse picking accuracy: clear reference printing reduces mis-picks and return handling.
• Transit-ready handling: lightweight exterior component supports tidy storage and consolidation.
• Fleet maintenance readiness: suitable for planned exterior refresh cycles during inspections.
• LH/RH stock control: supports pairing workflows when mirrored side panels are managed.

1. Preparation: park on level ground, apply the parking brake, and disconnect the battery.
2. Access: clean the work area and remove debris near panel edges and fixings.
3. Remove old panel: undo fixings/clips and support the panel to protect tabs.
4. Inspect mounting points: check brackets and seats for distortion or wear.
5. Test-fit: confirm guide point alignment and even edge seating.
6. Install new part: position the panel and start all fixings by hand.
7. Tighten evenly: secure progressively to maintain consistent gaps.
8. Final check: verify stable seating and no interference with adjacent trim.
9. Fleet note: record PJC4616015AE5BRQ for reorder control.

This is a direct-fit installation with plug-and-play compatibility for standard mounting points, and no special tools required for routine replacement.